Below is biomass briquetting knowledge about briquette press and production, shared by EP Machinery who is a reliabl briquette machine manufacturer dedicating to turn-key solutions to optimize production and maximize profits.

• Questions: The biomass briquette equipment cannot run normally after starting, and the motor makes an abnormal sound. What is going on?

• It may be a fault in the motor itself, such as short circuit, circuit breaking or bearing damage of the motor, etc.
• It may be that the transmission parts of the device are stuck, such as excessive tightness or foreign objects between the belt wheels and the belt, and there are debris entering between the gears.
• The power supply voltage is unstable and is not within the normal working voltage range of the motor.

• Question: During the operation of the biomass briquette machine, the phenomenon of frequent stoppopulation occurred, what are the reasons?

• The overload protection may be triggered, which may be that the biomass raw materials are too fast and too fast, which exceeds the normal processing capacity of the equipment.
• The temperature inside the equipment is too high, such as continuous operation for a long time, some key operating components such as pressure rollers and molds are not timely, and the temperature protection device is triggered.
• Some key sensor faults, such as sensors such as detection pressure, temperature, etc., causing the control system to determine the abnormality of the control system and stop.

• Question: It is easy to loosen after molding and the strength is not enough. What should I do?

• Excessive water content of biomass raw materials will cause it to be difficult to compact and loosen during the compression process. The appropriate water content of general biomass raw materials is about 10% -20%.
• The pressure of biomass briquettes machines is insufficient. It is necessary to check whether the hydraulic system or the mechanical transmission system can provide sufficient pressure, such as insufficient hydraulic oil, whether the hydraulic pump works normally, whether the gap between the pressure roller and the mold is appropriate.

• Question: What is the cause of the pressure of the block of the biomass briquettes machine?

• There is a problem with the mold. For example, the mold is severely worn after a long period of use, and the shape of the mold hole has changed.
• The installation location of the pressure roller is inaccurate, resulting in uneven pressure on the raw materials.
• If the distribution of biomass raw materials enter the mold is not uniform, this will also cause this.

• Question: How long should the biomass briquette machine be maintained?

• Generally speaking, daily maintenance needs to be carried out every day.
• If regular maintenance, it is recommended to perform small maintenance every 100-200 hours of operation, mainly to add lubricants to the transmission parts, check the tightness of the belt, check the oil quality and oil of the hydraulic oil, etc. A more comprehensive maintenance, including disassembling inspection of the equipment, cleaning up the dirt accumulated inside, replacing or repairing more severely damaged parts (such as pressure rollers, molds, etc.), and at the same time Perform comprehensive detection and debugging.

• Question: How to maintain the key components (such as pressure rollers, molds) of biomass briquette machine equipment?

• For pressure rollers, the raw materials residue should be cleaned in time after each use. Check the wear of the pressure roller regularly, and repairs or replace it in time. At the same time, it is necessary to regularly add an appropriate amount of high temperature and wear -resistant lubrication to the bearing part of the pressure roller according to the equipment requirements to ensure its flexibility.
• For molds, we must also timely clean up the residual raw materials in the mold hole to avoid blocking the effect of next use. You can use a professional mold cleaning agent to clean it to keep the smoothness of the mold holes. In addition, after a long period of use, fatigue cracks are prone to cause, and scratch detection (such as ultrasonic detection, etc.) should be performed on a regular basis. Once there are hidden dangers such as cracks, the mold should be replaced in time to ensure the safe operation of the block of blocks and equipment.